Shimmy Damper
PTS B1-L3 ATA32 Cessna 172 B2-L1 PTP Cessna 172 B1 LOC FOT SGH R/I MEL TS B2 LOC FOT SGH R/I MEL TS Shimmy Damper Servicing at every 100 hours : (1) Remove the shimmy damper. (2) While you hold the damper in a vertical position with the fitting end pointed down, pull the fitting end of the damper shaft to its limit of travel. (3) While you hold the damper in this position, fill the damper through the open end of the cylinder withhydraulic fluid. (4) Push the shaft up slowly to seal off filler hole. (5) Clean the damper with solvent. Make sure that the shaft comes out through the filler hole until the damper is installed on the aircraft. (6) Install the damper on the airplane. Shimmy Damper Servicing (Lord Shimmy Damper) Lord Shimmy Dampers do not need special servicing. lubrica...